Car Transporter Trailer

Tilt Drawbar Latches

 

tilt-latch-highlighted.png

The tilt latch can be purchased from your local trailer parts supplier (normally spring loaded) or you can fabricate one as below. Weld the latch to the drawbar along the length of the latch only. Do not weld across the ends of the latch.

If required, packers can be fitted to the front chassis crossmember angle gussets to reduce the gap between the gusset and the latch pin. Allow a little clearance for ease of use (1mm).

tilt-latch.png

Previous
Next

Jetski Trailer Plan

NZ$5.00

You can now purchase the full Jetski Trailer Plan and Construction Guide for only $5.00